Throttle Cable Adjustment - Stihl FS 120 Notice D'emploi

:
Place the secured assembly on the
handle support (8) with the wing
screw at the engine side.
:
Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
:
Line up the handlebar at a right
angle to the drive tube – check
dimension A again.
:
Tighten down the wing screw firmly
FS 120, FS 200, FS 250
Mounting the Control Handle
:
Loosen the screw (9). The nut (10)
remains in the control handle (11).
:
Push the control handle – throttle
trigger (12) must point toward the
gearbox – onto the handlebar (7) so
that the holes (13) line up.
:
Insert screw and tighten down
firmly.
English
14
15
15
14
15
Fitting the Throttle Cable
Do not kink the throttle cable or lay
it in tight radii – make sure the
throttle trigger moves freely.
:
Press the throttle cable (14) into the
retainers (15).

Throttle Cable Adjustment

On control handles with slide:
:
Go to chapter "Adjusting the
Throttle Cable".
* see "Guide to Using this Manual"
21