Adjusting The Throttle Cable; Mounting The Loop Handle - Stihl FS 80 Notice D'emploi

English

Adjusting the Throttle Cable

Bike handle only
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
22
2
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.

Mounting the Loop Handle

1
Loop handle with barrier bar
: Insert square nuts (1) in the barrier
bar (2).
: Line up the holes.
FS 80, FS 80 R, FS 85, FS 85 R
2
1
1