Troubleshooting - mundoclima MUPO-H8 Manuel D'installation

Troubleshooting

To save the cost of a service call, please try the suggestions below to see if you can
solve your problem without outside help.
Causes
The power switch is released.
●
Power supply failure.
●
The fuse is burnt.
●
It doesn't reach the setting time for
●
starting up.
Unit Doesn't Start When Pressing ON/OFF Button
Causes
It is not four minutes after switch off.
●
Room temperature is lower than the
●
setting temperature under cooling mode
or higher than setting temperature under
heating mode.
The Wind Blowing Out, But The Cooling / Heating Effect Is Bad
Causes
Mistakes in temperature setting.
●
The air filter is blocked by dust.
●
The air inlet or outlet of machine is
●
blocked.
Turn the air conditioner on in very
●
hot room.
Cooling capacity is insufficient.
●
The doors or windows are open.
●
Causes
The ground is not level or not flat enough.
●
Air Condition Will Not Operate
■
■
■
■
■
■
Noise or vibration
54
Solutions
Switch on the power.
Wait for the recovery of power supply.
Replace the fuse by professional .
Wait or eliminate the original setting.
Solutions
Wait four minutes.
Reset the setting temperature.
Solutions
Set a proper temperature, setting
■
temperature should be lower than
ambient temperature.
Clean the air filter.
■
Remove the obstruction.
■
Allow additional time to remove stored
■
heat from walls ,ceiling, floor and furniture.
Reconfirm the required cooling / heating.
■
capacity with your dealer.
Close the doors and windows.
■
Solutions
Place the unit on a flat, level ground
■
if possible.