Install The Exhaust Duct Into The Wall - mundoclima MUPO-H8 Manuel D'installation

Installation

Install the exhaust duct into the wall

1. Prepare a hole in the wall.
Install the wall exhaust
adaptor onto the wall, be
sure to fix thoroughly.
2. Attach the exhaust duct to
wall exhaust adaptor.(Fig.G)
Note: 1.The duct can be compressed to 270mm minimum and extended to 1500mm
maximum. It is better to keep the duct length to a minimum.
2.Stretching or bending the duct excessively will affect the cooling efficiency.
(As the following fig. Shows)
Without installation
If the unit does not have the window slider kit and wall exhaust, and the Adaptor B is like
this ,as shown in Fig H. You can open the window slightly and position as shown in Fig I.
Fig.H
Note: Cover the hole
using the adaptor cap
when not in use.
Do not!
51
Adaptor
cap
maximum:120cm
minimum:30cm
Fig.G
Yes!
Fig.I
Wall exhaust
adaptor
Adaptor B
(round mouth)