Operation - mundoclima MUPO-H8 Manuel D'installation

Operation

Failure to follow the below precaution could result in electrical shock, fire ,
explosion or personal injury.
1. The plug must be plugged into an individual socket that is properly installed and
grounded.
2. Do not use an extension cord or plug adaptor with this unit.
Before starting the unit
1. Select a suitable location, make sure the unit is near to an electrical outlet.
2. Install the flexible exhaust hose and the adjustable window slider kit.
3. Plug the unit into a right outlet.
Heating operation mode (Cool only unit has no heating function)
1. Press the MODE button in a sequence until the heat indicator is lighted.
2. Press the "+"and "- button to setting your desired setting temperature.
3. Press FAN button to select the fan speed.
Cooling operation mode
1. Press the MODE button in a sequence until the cool indicator is lighted.
2. Press the " "and " "button to set your desired setting temperature.
+
3. Press FAN button to select the fan speed.
Drying operation mode
1. Press the MODE button in a sequence until the dry indicator is lighted.
2. The fan will run at a fixed speed at this operation mode.
3. Close windows and doors for the best dehumidifying effect.
Note:
The setting temperature and fan speed can not be adjusted.The setting temperature
°F ) and the fan speed is low.
is 25℃(77
Fan operation mode
1. Press MODE button in a sequence until the fan indicator is lighted.
2. Press the FAN button to select the fan speed.
Note: The setting temperature can not be adjusted.
Auto-restart function:
If power to the unit is interrupted, the unit will restart itself in its last used mode /
settings once power is restored. The compressor will restart after 4 minutes.
1.Set: Press the sleep button 10 times within 5 seconds, buzzer sounds 4 times.
2.Cancel: Press the sleep button 10 times within 5 seconds, buzzer sounds 2 times.
WARNING
"
-
44