Start Up And Performance Testing; Adjustment Of The Static Pressure Of The Fan In The Models Mucr-H6M(V2) - mundoclima H6M Série Manuel D'installation

7. Start up and performance testing

Prior checks
-
Measure the voltage supply and make sure it is within the specified range.
-
Testing must be performed in all modes of operation.
-
To operate in cool mode, press the ON/OFF button of the remote controller to place the unit in
cooling mode and select a temperature below room temperature.
-
To operate in heat mode, press the ON/OFF button of the remote controller to place the unit in
heating mode and select a temperature above room temperature.
-
You can also check the manual button. This is used when you do not have the remote controller and
and is located under the front panel.

8. Adjustment of the static pressure of the fan in the models MUCR-H6M(V2)

The static pressure can only be adjusted using the RG57 remote control (optional CL94588):
Attention: The remote controller is only enabled within 10 minutes after hte indoor unit is powered on, and the indoor unit must be switched off.
1. After installing the batteries, during the first 30 seconds period, please holding down the MODE, FAN and TIME ON period,
please holding down the MODE, FAN and TIME ON buttons together for 5 seconds, the remote controller will enter
function reset state, and LCD window displays "F1":
2. Press & button to choose E9.
3. Press MODE button. Then press
choose the value between 0 and 4.
4. Press TIMER ON button to confirm.
To return the remote control to normal mode, you must remove the batteries for a moment and reinstall them.
External static pressure curves
MUCR-12-H6M(V2)
Air flow (m3/h)
(without filter)
1200
1100
1000
H
900
800
M
700
L
600
500
400
300
200
SP1-L
100
0
10
20
DRAIN JOINT and START UP AND PERFORMANCE TESTING
& button to
SP4-H
SP3-H
SP4-M
SP2-H
SP3-M
SP1-H
SP3-L
SP4-L
SP1-M
SP2-M
SP2-L
25
30
40 50
External static pressure (Pa)
TEMP TEMP
MUCR-18-H6M(V2)
Air flow (m3/h)
(without filter)
2000
1800
1600
1500 M H
1400
L
1200
1000
800
600 SP2-L
500
SP1-L
400
200
0
10 20 25 30 40 50 60 70 80 90 100 110 120 130 140 150 160
61
SP4-H
SP3-H
SP1-M SP4-M
SP3-L
SP3-M
SP1-H SP2-H
SP2-M SP4-L
External static pressure (Pa)
SP1 (Setting 1)
SP2 (Setting 2)
SP3 (Setting 3)
SP4 (Setting 4)
ON/OFF SHORT
CUT
TIMER
MODE
ON
TEMP
TIMER
FAN
OFF
SLEEP
TURBO LED