Siemens SIMOVERT MASTERDRIVES Motion Control Instructions De Service page 340

Faults and Alarms
Number / Alarm Cause
A172 The program number specified in [PROG_NO]
for automatic mode is not stored in the
Program with this memory of the technology.
number does not exist
Effect:
NC program execution is inhibited.
A173 The program number specified in [PROG_NO]
for automatic mode is not allowed.
Program number not
allowed Effect:
NC program execution is inhibited.
A174 The program number [PROG_NO] was
changed while the program was running.
Program number
changed during Effect:
traversing NC program execution is aborted and the axis
or axes are brought to a standstill via the
deceleration ramp.
A175 The decoded NC block is not terminated with
the following block identifier "0".
No block end
programmed You can use the "output actual values -
decoder error location" task to read out the
program number and block number where the
block decoder detected an error.
Effect:
NC program execution is inhibited or aborted.
Moving axes are stopped via the deceleration
ramp.
A177 The program number for the main program
(level 0), which was transferred with the block
Prog. number of block search function, does not exist.
search forwd. does not
exist Effect:
NC program execution is inhibited.
A178 -The program number for the main program
(level 0), which was transferred with block
Program number of search, is different from the selected program
block search forward number.
not allowed
-No breakpoint is known for the "automatic
block search" function (a program abort has
not yet occurred).
-A different program number is stored as the
breakpoint for the "automatic block search"
function.
Effect:
NC program execution is inhibited.
A179 The subprogram number specified with block
search for level 1 or level 2 does not exist.
Prog.No.of block srch
fwd level 1/2 does not Effect:
exist NC program execution is inhibited.
A180 The subprogram number transferred with
block search for level 1 is not the same as the
Prog.no. of block subprogram number in the NC block.
search forward level 1
<> cmd. Effect:
NC program execution is inhibited.
A181 The subprogram number transferred with
block search for level 2 is not the same as the
Prog.no. of block subprogram number in the NC block.
search forward level 2
<> cmd. Effect:
NC program execution is inhibited.
12-26
Counter-measure
-Transfer the program to the technology.
-Select the correct program number.
The permissible range for program numbers is
between 1 and 200.
The program number must not be changed
while the program is running.
Correct the block.
The last block in the sequence must contain
the following block identifier "0".
Specify an existing main program number.
For the block search function, the selected
program number [PROG_NO] must be
specified as the program number for the main
program.
For the block search function, an existing
program number must be specified as the
subprogram number for level 1 or level 2.
For the block search function, the subprogram
number specified in the NC block must be
specified as the subprogram number for level
1.
For the block search function, the subprogram
number specified in the NC block must be
specified as the subprogram number for level
2.
6SE7087-7JK50
Operating Instructions SIMOVERT MASTERDRIVES
09.2006
Siemens AG