Installing Units Of Types E, F, G - Siemens SIMOVERT MASTERDRIVES Motion Control Instructions De Service

09.2006
5.1.1

Installing units of types E, F, G

Siemens AG 6SE7087-7JK50
SIMOVERT MASTERDRIVES
Cooling air
Fig. 5-1 Minimum clearances for cooling air requirement (types E, F, G)
The following are required for mounting:
♦ Dimension drawing for the relevant type of construction
♦ Four M8 screws
Mounting surface
10 mm
350 mm
Side view
Fig. 5-2 Dimension drawing for types E, F
Operating Instructions
Mounting surface
Type E,F
Clearances 400
[mm]
Cutouts
for M8 screw
10 mm
180 mm
270 mm
Type E
Front view
Installation
G
320
270 mm
360 mm
Type F
5-3