Fulgor Milano PRO-RANGE 30 Guide D'utilisation Et D'entretien page 40

26 - Element and Control Setting
EN
Melting function
If the knob is turned clockwise from zero position the first "power level" reached is the melting function.
The according 7 segment display unit shows this "u" symbol. The melting function is used to heat up
the bottom of the pot (40°C / 105°F inside the pot). This function is used to melt food. The maximum
time for using the melting function is limited to 2 hours.
Warming function
The warming function is the second "power level" which will be selected when turning the knob
clockwise. The according 7 segment display unit shows this "U" symbol. The warming function is used
to heat up the bottom of the pot to 70°C / 160°F (65°C / 150°F inside the pot). Using this function
the food can be kept warm or it can be used to warm up food gently.
The maximum time for using the warming function is limited to 2 hours.
Automatic Heat Up time function
To activate the heat up time automatic press and turn the knob counterwise in overwind position "A"
until a beep sounds and the "A" symbol on the display starts blinking waiting for an input. Within the
next 10s a valid cooking level has to be selected from 1 to 8.
This will be the cooking level after a defined time of higher power output at level 9. The 7 segment
display alternates between "A" and the selected cooking level.
If the knob is turned clockwise by selecting level 0, level 9, (warming, melting) or in any position
counterwise the automatic heat up function will be turned off.
Booster function
To activate the boost function press and turn the knob clockwise in overwind position "P" until a beep
sounds. The symbol is as shown "P" and will be displayed. After 10 minutes the boost function will be
automatically switched off and the "P" is not shown on the display anymore and the induction control
will be set automatically at level 9.
Cookware recognition function
The cooking level of cooking zone can be selected by turning the knob to the according position even
if no pot is in place. The output of power starts automatically as soon as an appropriate pot is put on
the cooking zone. If no pot is being detected the display changes to the shown "pot missing" symbol
after a short time. This symbol will be shown until a appropriate pot is put on the cooking zone or the
maximum time of 10 minutes expired. The same applies if the pot is removed during normal cooking.
After 10 minutes without detected pot the cooking zone switches off automatically and can only be
activated again after returning the knob into the OFF position.
Control Lock function
The control lock is a device that protects the appliance from accidental or inappropriate use. With all
cooking zones turned off, simultaneously press and turn the first two left knobs counterwise in overwind
position "A". They need to be hold in that position for a least 2s until the symbols "L" appear on the
displays, then release the knobs.
In order to deactivate the CL function repeat the same procedure as for activating.
After unlocking all knobs have to be turned back in the zero position (if any knob was in a position
different from zero). The control is than off and can be operated as expected.
NOTE: If the knobs are not hold in the OWL position for long enough the CL will not be enabled /
displayed. If the knobs are hold in that position for more than 30 seconds the input is considered to be
invalid and a error message "Permanent use of key" will be displayed (flash symbol ).
Residual Heat indication
Cooking zones which are already switched off can still have a hot glass surface. In order to warn and
protect users from burning themselves this condition is visualized, the residual heat measurement is
done from the temperature sensor of each inductive cooking zone..
When the measured temperature drops below 60°C / 140°F on the glass the symbol indicating the
hot surface disappears.
36