Assembly - Becker BECK-O-TRONIC 5 Basic Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Deleting the handheld transmitter
To.delete.the.handheld.transmitter,.press.the.Radio.PRG.BUTTON.until.the.green.LED.
flashes.very.quickly.and.the.BECK-O-TRONIC.5.Basic.switches.back.to.the.operating.
mode..This.process.deletes.all.the.programmed.handheld.transmitters.
16
4.. Press.the.button.on.the.handheld.transmitter.
which.is.to.be.programmed.
After. successful. programming. of. the. handheld.
transmitter,.the.BECK-O-TRONIC.5.Basic.switch-
es.back.to.operating.mode.(green.LED.lights.up)..
This.procedure.can.be.used.to.program.a.total.of.
ten. buttons. or. handheld. transmitters. (1-chan-
nel).
5.. Close.the.BECK-O-TRONIC.5.Basic.

Assembly

Test.correct.functioning.of.the.transmitter.and.re-
ceiver. at. the. desired. installation. site. prior. to. as-
sembly.
Open. the. lid. of. the. control. unit.. Disconnect. the.
"Impulse".button.from.the.control.unit.and.place.
the.lid.to.one.side.
Remove.the.required.cut-outs.in.the.lower.part.of.
the.housing.
Note
Slit the edges to facilitate easier removal of
the cut-outs.
To. fix. the. housing. into. position,. insert. 1. screw.
(Screwhead.max..Ø.7.5.mm).into.each.mounting.
hole.at.the.corners.