Patio heater functions
The top of the patio heater can tilt to around
35°; set it to the position you prefer.
The height of the heater top can be adjusted
with the S-system. The black locking screw
(15) on the upper stand section must be
undone and the adjustable stand section can
be pushed in/out of the upper section. Then
tighten the screw up firmly. The heater head
must always be kept at least 180 cm above
the floor.
Check that all of the safety requirements
have been fulfilled.
Now insert the plug into the socket (220-240V-50Hz).
By pressing one of the two operating switches (I pressed), you can set the patio
heater to half power (1000W). By pressing the other switch in too, you can also
switch the second light on and the device works at full power (2000W). Switch
off the lamps by pressing the switches again (O pressed).
The patio heater does not have a thermostat and continues to give out heat until
it is switched off. Always keep a close eye on the patio heater when it is
switched on!
Remove the plug from the socket when the patio heater is not in use.
Fall protection
The Q-Time 2000S is equipped a fall safeguard. It will automatically switch off if,
despite the precautionary measures you have taken, the device falls over.
In this event, unplug the device immediately.
Always check the patio heater carefully for damage, then put it upright again.
Never use a damaged device but take it to your dealer or a recognised service point
to be checked and/or repaired.
If you cannot find any damage, switch the patio heater off, insert the plug into the
socket and put the device on again. Monitor the patio heater closely for the first
fifteen minutes; if any defects occur, unplug immediately and take it to your
dealer/service point to be repaired.
Cleaning
Always switch the patio heater off, allow the patio heater to cool down and unplug
before cleaning. Clean using a damp cloth and, if necessary, a little cleaning fluid.
Never use corrosive or abrasive cleaning agents!
18