EUROM Q-time 2000 Manuel D'utilisation page 17

Assembling the stand (only S version)
 Place the bottom section of the stand (9, with the
fastening plate) on the base (8), in such a way
that the screw holes are aligned. Turn the foot
over and screw the lower section of the stand
from below with the plate and the locking nut (see
diagram). Turn the base the right way up.Insert
the 3 bolts through the double holes and tighten
them firmly. Place the protective cover over the
screw connection.
 Slide the adjustable, narrow section of the stand (12) from below through the
top section of the stand (11), until it comes out again at the top (widening at the
base). Secure the adjustable section using the black
locking screw (15) that is located at the top of the top
section of the stand.
 Push the centre section of the stand (10) into the lower
section (9), screw-hole to screw-hole. Secure with four
fixing screws. In the same way, secure the upper
section of the stand (11, with the adjustable part inside)
over the central section.
 Screw the extra black colored screw (supplied) into the
adjustable section of the stand so that it cannot, so that
it cannot slide into the upper section (to secure the movable pipe).
 Then undo the hanging screw (7) almost entirely. Place the top of the patio
heater over the top of the adjustable stand section so that the hanging screw
falls precisely into the recess on the stand. Now tighten the screw firmly. The
electrical cable can be secured in the cable holders on the stand.
 Check that all connections are completely secure and that the terrace heater is
securely positioned before using it.
 The terrace heater must be placed at a distance of at least 1 metre from the
nearest wall. The box with the radiator lights must be at least 30 cm from a
ceiling and 1.80 metres above the ground. The terrace heater must be placed
firmly on an even and completely horizontal surface.
Stand Q-Time 2000S
The stand that is supplied with the Q-Time 2000S is multifunctional.
In the top of the narrow stand section, there is a threaded section; a
suitable screw with a black top is also supplied. You can, therefore,
also mount a lamp on the stand (see diagram).
17