EUROM ALUTHERM BASEBOARD Wi-Fi Manuel D'utilisation page 49

floor and horizontal. Push plugs into the drilled holes and screw the brackets to
the wall using the 2 large screws.
Hang the heater on both brackets and let it drop into the channels.

Check to ensure your heater is horizontal and secure, with the minimum distance

to the floor, ceiling and any side walls.
Freestanding
Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the heater to

prevent damage!
Place the feet on their place on the bottom of the heater. This will ensure that the

threaded holes will align correctly.
Securely attach the feet to the heater using the (2x2) self-tapping screws.

Return the heater to the upright position.

Make sure a working heater is always placed on a solid, flat and horizontal surface.

Deep-pile carpeting is unsuitable!
Using for the first time and operation
 Check to make sure the main switch on the bottom of the heater is set to O
(off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The display will show: OFF
External temperature sensor
Because the temperature sensor is located on the heater, it does
not measure the external temperature very accurately. If you
want accurate measuring, connect the separate thermostat
(included in the delivery) by inserting the small plug into the
control panel and placing the sensor approx. 2 metres away
from the heater (see illustration). For this purpose, you should
49