EUROM ALUTHERM BASEBOARD Wi-Fi Manuel D'utilisation page 52

Screen protection: If the settings on a working heater are not adjusted for 2
minutes, the LED display will go out but ON will stay on. It will light up again when
you press a button. If the heather is switched off using the ON/OFF button, the OFF
screen will stay on.
Using with the remote control:
The remote control (5) has the same 6 buttons as the operating
panel (MOD = MODE) and works in roughly the same way, but:
 You cannot use the remote control (under M-mode) to set
the capacity with the + or - buttons. Use the bar
button for this purpose.
 The remote control has an ECO button for an energy efficient
mode; the heater maintains the room at 16°C. The
screen shows EC. Deactivate by pressing ECO again.
Nothing else can be set under this setting. If the
heater is working on ECO setting and a timer setting
becomes active, the heater will start to work according to
the timer setting. When the heat goes off, the heater will not
return to the ECO setting, but go off.
 The remote control also has an open-window detection;
when you choose this function, the heater will turn
itself off when the temperature in the room drops by
8 or more degrees in 15 minutes. Turn the heater
on again with the on/off button. Press the symbol
again to cancel the open-window detection. The
heater will begin to work in the pre-set function. When the heater operates
according to a set week programme and you turn on the open-window detection,
the heater will only work during the set operating times of the week programme.
Working with the app via wifi:
The heater can also be operated using an app on your smartphone. The heater
must be connected with a wifi modem. See the back of the booklet for instructions
on how to install the app. By activating the app on your smartphone or tablet, and
selecting the device, you can operate the heater with the smartphone. You do not
need to set a day or time as they are set automatically (both on the app and on the
display).
You can use the app to switch the device on and off, regulate the temperature and
capacity, set the ECO setting and open-window detection. The app can also be used
to set 20 on and off settings daily, on the weekly timer.
If the device is connected with wifi and is switched on, the display will show
(during screen saver) the wifi symbol and ON. If the device is connected to
wifi but switched off, the display will show the wifi symbol and OFF.
52