EUROM ALUTHERM BASEBOARD Wi-Fi Manuel D'utilisation page 51

one of the four possible settings on that day. You are better off deleting it, see
later.
Please Note: The choice of 'one-off' or 'repeated' and now applies to all timer
settings!
 "01 SET ON" appears on the screen to signify that you can set the first 'on' time.
You can now use the + and – buttons to select the day of the week for the
setting. Press SET for the right day.
 The temperature (standard 25°) now appears on the display and blinks. Use the
+ and – buttons to adjust it, from 0 to 37°C. Confirm with SET.
 The hour will now blink. Choose the right hour and confirm with SET.
 The minutes will now blink. Choose the right minutes and confirm with SET. The
first activation time is now set.
 Now, "01 SET OFF" will appear on the display, to indicate that you must set the
deactivation time. Do this in the same way as set out in the above 2 points. Your
first setting is now entered.
A '02' will now appear on the display. You can now set a second
activation/deactivation time; a total of 4 per day and 28 per week. If you don't
need to, wait until the screen returns to the standard settings.
Attention! All timer settings (maximum 28 per week) will be processed completely
one by one. Therefore, make sure that they do not contradict each other!
 Now switch the heater on using the ON/OFF switch. The screen will show P and
OFF to indicate that a setting has been programmed but that the heater is
currently off. At the set time, it will switch on and off automatically.
 The set timer details will be retained after it is switched off using the main
switch or plug.
 If you press repeatedly on WEEK, you will see the following timer settings, one
after the other:
One-off or repeated
-
Thermostat setting
-
Timer on-time
-
Timer off-time
-
Next timer setting
-
 If you would like to delete a specific setting, press and hold WEEK and then
search for the timer setting that you need. Go past 01- ][ and on/off first by
pressing SET briefly. When the number of the timer setting that you wish to
change appears, press SET for a little longer. You will hear a short beep and the
selected setting has been deleted.
 If you wish to delete all timer settings, press the WEEK button and hold. Press
and hold the MOD and SET buttons at the same time, until you hear a beep. The
screen will show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the
operating panel, not with the remote control!
 If you wish to retain the timer details but do not want to use the timer for a
while, push and hold the WEEK button and then push and hold the MOD until
TIME disappears from the screen to indicate that the data will be retained but
will not be active. By pressing MOD again until TIME appears, you will reactivate
the timer.
51