EUROM ALUTHERM 400XS Manuel D'utilisation page 53

Using for the first time and operation
 Check to make sure the main switch is set to O (off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The display will show: OFF
Using the operating panel:
The operating panel (3) has 6 buttons:
MOD / SET / WEEK / + / - / ON-OFF
 Press the ON/OFF button in order to switch the heater on. The display lights up
and the heater can be operated.
 Now, set the day and time. Press and hold SET until SET appears on the screen.
The numbers of the weekdays (line 4) will blink. Use the + and – buttons to find
the right day (1 – Monday, 2 = Tuesday, etc.) and confirm with SET. The hour
will now blink. Use the + and – buttons to set the right hour and confirm with
SET. The minutes will now blink. Use the + and – buttons to set the right
minutes and confirm with SET. The day and time are now set.
Please Note:
The day and time settings will be lost if the heater is switched off using the
o
main switch or plug; these will be retained if the ON/OFF button is used.
If you do not set a time and day, the heater will assume that it is day 1 and
o
00.00.
The screen goes off automatically after 2 minutes and can be turned on again
o
with any button.
 Press MOD to set whether you wish to work with the M or P function.
Under the M-function, you use the + and – buttons (remote control: with the bar
button) to set the capacity at which the heater will work: low, medium or high -
see technical details. The thermostat cannot be adjusted.
Note: Does not apply to Alutherm 400XS, this model only has 1 heating level
(400W full power).
 Under the P-function, you can use the + and – buttons to set the desired
temperature for the heater, which it will then try to maintain. The heater will
automatically select the correct capacity: 1 or 2 degrees of heat = low, 3, 4 or 5
degrees of heat is medium and 6 or more degrees of heat is high. Once the
desired temperature is reached, the heater automatically turns off, and then
back on again when it cools down.
Note: Does not apply to Alutherm 400XS, this model only has 1 heating level
(400W full power).
 Under the P-function, you can also set the weekly timer. Pressing WEEK, allows
you to set or check the weekly timer. Please note! To set the weekly timer, you
must first enter the day and time correctly.
53