EUROM ALUTHERM 400XS Manuel D'utilisation page 52

Secure the 2 hanging brackets o the wall. Choose a left and a right bracket and

secure them with the channel to the top, the short sides against the wall and
facing one another (see diagram). Drill 2 holes in the wall, with a distance of
195 mm (Alutherm 400XS) / 255 mm (Alutherm
800XS) / 400 mm (Alutherm 1200XS)
them, at least 61 cm. above the floor and horizontal.
Push plugs into the drilled holes and screw the brackets
to the wall using the 2 large screws.
Screw the other 2 brackets with the smaller screws

below the heater, in the relevant holes (see diagram):
screw through the long side of the bracket, the short
side facing down. The short side will come to lie against
the wall.
Hang the heater on both brackets and let it drop into

the channels.
The short sides of the other 2 brackets will fall against the wall. Mark where

these must be screwed to the wall and lift the heater out of the brackets.
Drill 2 holes at the marked locations and insert plugs.

Hang the heater back on the brackets, let it drop into the channels and screw

the last 2 large screws through the lower brackets against the wall.
Check to ensure your heater is horizontal and secure, with the minimum

distance to the floor, ceiling and any side walls.
Freestanding
Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the heater to

prevent damage!
Place the feet on their place on the bottom of the heater. This will ensure that

the threaded holes will align correctly.
Securely attach the feet to the heater using the (2x2) self-tapping screws.

Return the heater to the upright position.

Make sure a working heater is always placed on a solid, flat and horizontal

surface. Deep-pile carpeting is unsuitable!
between
52