Blackout-Socket; Dmx-512 Connection / Connection Between Fixtures - Futurelight DJ-SCAN 210 Mode D'emploi

Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please note: The function N3N is only meant for service-purposes. Please do only use this function if you
want to set the unit shortly into standby mode. If the unit remains on N3N, it cannot be controlled by DMX
anymore!

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode), connect your footswitch
via a mono-jack plug to the Blackout-socket. Contact closure between tip and sleeve is reached when the
footswitch is employed.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
27/60 51839230_V_1_1.DOC