Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode), connect your footswitch
via a stereo-jack plug to the Blackout-socket.
DMX-512 connection / connection between fixtures
Projector 1
Starting address 1
1
2
3
2
1
3
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Stereo 1/4" jack-plug:
Tip
- 5 V
Projector 2
Starting address 6
1
2
3
2
1
3
DMX-512 Controller
the fixtures will not work at all, or will not work properly.
Ring Sleeve
Black Out
Ground
24/53
Projector 3
Starting address 11
1
2
3
2
1
3
51837558_V_1_2.DOC
120 Ohms

Publicité

Table des Matières
loading

Table des Matières