Wall Installation - switel DC682 Combo Mode D'emploi

Starting Up
Positioning the telephone (base station)
115
You can set the telephone (base station) down in a convenient, inclined position. To do
this, hook the stand supplied in the recesses (2) on the underside of the telephone
(base station) and then lock it in the notches (1).

Wall installation

The telephone (base station) can be mounted on a wall.
Screw two screws (not supplied with the telephone) in the wall: The screws must be
100 mm apart, vertical to each other and 5 mm must remain projecting from the wall.
To mount the telephone (base station), fit the holes in the underside of the telephone
over the screws in the wall and then lower the telephone gently until it is firmly fixed.
To ensure the receiver does not slip from the hook when the telephone is installed on a
wall, slide out the receiver hook from the telephone (base station). When the equipment
leaves the factory, the receiver hook is in a countersunk position (for positioning the
telephone on a flat surface). Slide the receiver hook out upwards.
Receiver hook
168
2
1