Measuring - VOLTCRAFT VC830 Notice D'emploi

MΩ Mega Ohm (exp.6)
nF Nanofarad (unit of electric capacity, exp.-9, symbol
µF Microfarad (exp.-6)
Symbol for the capacity measuring range
WARNING! Warning symbol for voltages >30 V AC/DC, Low imp function and wrongly
connected measuring lines
Symbol for data transfer (active RS232 interfaces)
Bar graph (only for V, A, Ω)
Symbol for the integrated fuses

Measuring

Do not exceed the maximum permitted input values. Do not touch any circuits or
parts of circuits if there could be voltages higher than 25 V ACrms or 35 V DC
present within them. Danger to life!
Before measuring, check the connected measuring lines for damage such as, for
example, cuts, cracks or squeezing. Defective measuring cables must no longer
be used. Mortal danger!
During measuring, do not grip beyond the tangible grip range markings present
on the test prods.
Measuring is only permitted when the battery and fuse compartment is closed.
When the compartment is open, all measuring jacks are mechanically secured
against insertion.
You may only connect the two measuring lines to the measuring device that are
required for measuring operation. Remove all measuring lines not required from
the device for safety reasons.
Measurements in electrical circuits >50 V/AC and >75 V/DC must only be carried
out by specialists and technically instructed personnel who are familiar with the
relevant regulations and the ensuing risks.
As soon as "OL" (overload) appears on the display, you have exceeded the measuring
range.
)
37