Adding Fuel / Heating At Nominal Thermal Output; Emptying The Ash Drawer - HASE Modena Mode D'emploi

7.

Adding Fuel / Heating at Nominal Thermal Output

More fuel should be added to the fi re when the fl ames from
the previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure
Adjust primary and
secondary air.
Close fi re grate.
Add two logs weighing approx.
2 kg in total. Place logs with
one end to the front of fi re box.
Only add a single layer of fuel.
Close fi re box door
Tab. 2
fi g. 4
32
8.

Emptying the Ash Drawer

As a safety precaution, please make sure to wait until the
ashes are cold before you dispose of them. While the ash
collects during the fi re, the lid is located under the ash drawer.
Remove both the ash drawer and the lid located underneath
Position of
it. Slide the lid onto the ash drawer so that it is closed; this
Control Elements
prevents ashes from fl ying around, which in turn means your
home stays clean. To place the ash drawer back into the stove,
Close primary air slider
(I), set secondary air
proceed in the reverse order.
slider (II) to position 2.
Push in fi re grate slider.
[a]
Open fi re box door
supply of primary air supply to the stove.
Please ensure that the air supply path for the
primary air between the ash drawer and the
bottom of the ash compartment remains clear.
CAUTION!
Piled up ashes can impair or even block the