patura P5500 Mode D'emploi page 51

To change the energiser's address:
1. Switch to the standby mode. See procedure above.
2. Press and hold
3. Press and hold
4. Select the address (Ad) option, and press
5. Hold the Remote Control Fence Compass within 150 to 300 mm (6 to 12") of the energiser
and press , to transmit the new setting to the energiser.
A moving arrow on the Remote Control Fence Compass screen indicates that the command
is being sent to the energiser. The large, red light on the left illuminates for 6 seconds as
the energiser receives the command. The energiser then resumes in standby mode with
only the large, green light on the right flashing.
6. Press to switch off the Remote Control Fence Compass.
To exit the set-up mode without changing the energiser's address:
• Instead of pressing
remote control.
Tip:
Make a note of the address setting of the energiser to save time should the address be
accidentally changed or if an additional Remote Control Fence Compass is required in the
future.
To reduce the risk of accidental address changes, the energiser has been built with the follo­
wing safeguards:
• It will accept a new address only within four minutes of the power supply being switched on.
• It will accept a new address only when in standby mode (that is, when the energiser is not
pulsing).
Activating the remote control function of a remote ready energiser
An energiser purchased as remote ready will not respond to commands sent by the Remote
Control Fence Compass until the remote control function has been activated.
Before activating the remote control function:
• Switch off the power supply to the energiser and wait for the red power light to stop illumi­
nating, then switch on the power supply again.
To activate the function:
1. Press and hold
2. Press and hold
3. Select the address (Ad) option, and press
4. Hold the Remote Control Fence Compass within 150 to 300 mm (6 to 12") of the energiser
, then press to enter the set­up mode.
to scroll through the list of available options.
, which transmits the new setting, press
, then press to enter the set­up mode.
to scroll through the list of available options.
until the number you want is displayed.
until the number you want is displayed.
- 51 -
. This switches off the