patura P5500 Mode D'emploi page 50

Adresse
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Note:
If only the large, red light segment on the left is illuminated, your energiser is set to
zero.
This means that you have a remote ready energiser.
Changing the energiser's address setting
To switch to the standby mode:
1. Switch off the power supply to the energiser and wait for the red power light to stop illumi­
nating, then switch on the power supply again.
2. Press to switch on the remote control.
3. Hold the Remote Control Fence Compass within 150 to 300 mm (6 to 12") of the energiser
and press . The energiser will stop pulsing (may take up to 2 seconds) and only the
large, green light on the right will continue flashing.
4. Press to switch off the remote control.
- 50 -