Publicité
Les langues disponibles
Les langues disponibles
1
2
Side grip
1
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
1
3
2
4
CAUTION:
•
Never use A-type shank bits. They can cause dam-
age to the tool.
37
27
19
19
A
003582
1. Side handle
2. Clamp nut
003147
1. Side grip
003151
1. Bit for drilling
2. Bit shank
3. Bit grease
4. Bit for chipping,
scaling or
demolishing
003155
38.5
37
16ø
B
Make sure that the
the tool. If the
mark is not visible, pull the chuck cover
down until it is visible.
For drilling
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
2
For chipping, scaling or demolishing
With the cut in the bit shank aligned with the notch in the
tool holder cap, insert the bit into the tool holder.
1
The chuck cover will slide up automatically and cover the
mark.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
6
mark is visible on the top end of
003156
1.
mark
1
2. Chuck cover
2
003162
1. Bit
2. Chuck cover
003164
1. Cut in bit shank
2. Notch in tool
holder cap
2
003169
1. Bit
1
2. Chuck cover
2
Publicité
