Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
14
Emergency procedure
Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site, 2.
Accident type, 3. Number of injured persons, 4. Injury
type(s)
Symbols
WARNING/CAUTION!
<<WARNUNG>> - Read the operating
instructions to reduce the risk of injury.
Unplug the machine before any work
on it.
Cable pulling / transport prohibited
Staying in the transportation medium
prohibited
Warning against dangerous electric
voltage
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
CE marking
Safety Instructions
Do not grab the feeder cable, plunge the pump, lift or
carry it while it is connected to the grid!
Unplug the device prior to submersion, upon termi-
nation of operation, in the course of defect removal
and prior to performing maintenance procedures.
If the pump is in operation, neither people nor animals
can be present or plunged in the pumped liquid (e.g.
pools, cellars, etc.).
The temperature of the drained liquid must not
exceed +35 °C.
The pump must not in any case run without fillings.
Do not leave the pump unattended while in operati-
on in order to prevent subsequent damages caused
by eventual malfunctions. Make sure to disconnect
the device from the grid if you do not plan on using it.
If the pump is used in ponds, wells, etc. and appropri-
ate pumping stations, standards valid for pumps in
the given country must unconditionally be observed.
The user is responsible to third parties if pump (dum-
ping stations, etc.) is used.
Check the cable and/or socket for damages before
the appliance putting into operation.
Do not expose the appliance to rain and do not use it
in wet or moisture conditions.
Avoid installing the appliance in wet shafts (risk of
short circuit, corrosion effects)!
When using the pump for domestic water supply,
always observe the local regulations of water ma-
nagement authorities and the waste water drainage.
In cold weather, the pumping body motor should not
be wrapped in a blanket or another piece of textile
with intent to prevent the water freezing.
Mains Connection
Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
WARNING! Electric shock! There is a risk of an
injury caused by electric shock!
Before putting into operation, a qualified electrician
must check whether electric safety measures required
are in place. Any national regulations in this regard
must be complied with.
Electric connection to a socket.
Check the voltage. Technical data given on the type
label must correspond with electric network voltage.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity.
Only use splash proof extension cables approved for
outdoor purposes.
Protect the feeder cable from excessive temperatures,
oil and sharp edges.
Publicité
