Preparation And Power Supply - CombiSteel 7487.0165 Mode D'emploi

Far from heat source
Never place the refrigerator directly under the
sunshine. Never locate it nearby any heat source or
heater to prevent it from reducing refrigeration
capability.
No hole making
Never make a hole on the refrigerator. Never install
other matter on the refrigerator.

Preparation and power supply

Exclusive power socket
Normally, the power supply should be 220-240V
single phase AC with exclusive single phase three pin
receptacle (250V, 10A) and fuse (6A). The power
receptacle must have a reliable earth connection.
Protect cables
Never break or damage the cables otherwise current
leakage and fire may occur.
Prevent from flammables and explosives
Never put any flammables or explosives inside the
refrigerator such as ether, gasoline, alcohol, adhesive
and explosive. Never put dangerous products nearby
the refrigerator.
After power break
After power break or unplugging the refrigerator,
always wait at least 5 minutes and then you may plug
the refrigerator and start it again.
No heavy load
Never put any heavy load on the top of the
refrigerator.
Stable location
Unpack and locate the refrigerator on a flat and solid
place.
No share on socket
Never let the refrigerator share the common socket
with other appliances, otherwise the cable becomes
hot and fire may occur.
No water flushing
Never give the refrigerator surface a flush otherwise
current leakage may occur.
No spray
To spray the flammables such as paint or coating
nearby the refrigerator is not allowed, otherwise fire
may occur.
No medicine
No medicine is allowed to keep inside the refrigerator.
www.combisteel.com
4