Informations And Equipments Related To Product; Description Of Device With Explanations; Replacing The Device And Preparing For Start Up; Installation Before Assembling - CombiSteel 7478,0515 Mode D'emploi

Power cord must be min. H05RN-F type.
Grounding line must be continuously checked.
We recommend installing the machine under a range hood so that all fumes are removed quickly as possible.
If the appliance is to be installed near the wall etc. This should be non-inflameble meterial or covered with non-inflameble meterial or it
is necesasary to keep machine far at least 100 mm
7.

INFORMATIONS AND EQUIPMENTS RELATED TO PRODUCT

A. Description Catalogue
B. User/Maintenance/Assembling Manual
Dear Customers, please check the above written auxiliary equipment to be given with the machine on delivery. If you notice any damage or
loss occurred during the transportation then you should request the transporter to issue any written report including the relevant damage or
loss.
8.

DESCRIPTION OF DEVICE WITH EXPLANATIONS

The device have wholly manufactured regarding to hygienic standards.
Outside, inside and all surfaces contacting to the food of the device have been manufactured completely stainless steel material.
The legs are in adjustable feature and manufactured by stainless steel material.
For the insulation purposes, glass- wool and stone–wool have been used. Thanks to this application, wasting of
prevent.
Electrical operated devices have been secured completely by means of thermal and electrical relays.
Accesses to control panel, maintenance and checking have been facilitated.
Electrical components and cable are complied with the relevant standards.
9.

REPLACING THE DEVICE AND PREPARING FOR START UP

INSTALLATION BEFORE ASSEMBLING

Open the packing of the device and remove all protective tapes.
Opening the cover of the device, take out the instruction manual and guarantee document.
Place the devices with adjustable legs by adjusting their legs and the device with fixed legs by aligning the ground.
Make the grounding connection thoroughly.
Be sure that the energy supplied.
Authorized and certificated people must make all these connection.
Now, your device is ready for use.
DISCONNECTION: Disconnection of the machine is to do via disconnect all poles (R,S,T,N).

PREPARATION FOR START UP

Assuming that electrical installation connections have already made by competent technicians, the user must implement the following
simple inspections
Be sure that in electrical operated devices, the electricity current has been supplied in adequate features as stated in TECHNICAL DATA
catalogue and grounding connection has been complemented. .
Read the instruction and maintenance manual absolutely.

FINAL CHECK BEFORE START UP

The users should fulfill the following last-controls by accepting
wastewater ,nstallations to be carried out by the authorized technicians;
You must be sure that the power supply and grounding installation are ensured as required in leaflets of electrical equipment.
the required couplings of fresh water, electric,
15/36
energy can be able to