Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Safety regulations and warnings
1.1 General
The manufacturer does not accept any liability for damage or injury caused by not (strictly) complying with the
safety regulations and instructions in this document, or by negligence during installation, use and maintenance
of the device mentioned on the cover of this document and any associated accessories. Depending on the
specific work conditions or used accessories additional safety instructions may be necessary. In case of a
malfunction or defect please contact Combisteel.
The user of the device is always responsible for the compliance with the local applicable safety regulations
and guidelines.
1.2 Use instructions
•
Anyone working on or with the device, must be aware of the content of this document and strictly follow
the instructions therein. The management must educate the staff based on this document and observe
all regulations and instructions.
•
Never change the order of the actions to be performed.
•
Always keep this document in the vicinity of the device.
1.3 Icons and instructions on the device (if present)
The icons, warnings and instructions applied to the device are part of the safety provisions. They may not be
covered or removed and must be present and legible during the entire lifespan of the device. Immediately
replace or repair any illegible or damaged icons, warnings and instructions.
1.4 Users
The device may only be used by users who have been training and authorised thereto. Temporary staff and staff
in training may only use the device under the supervision and responsibility of authorised users.
1.5 Intended use*
The device is only designed to keep products cool, any other use is considered as improper use. The manufacturer
does not accept any liable for damage or injury arising thereof. The device is in accordance with the applicable
standards and guidelines. Only use the device in a technically good condition.
1.6 Technical specifications
The specifications mentioned in this document may not be adjusted.
•
The "Intended used" as stipulated in the EN 292-1 is the use for which the technical product is suitable
according to the statement of the manufacturer and his instructions in the sales brochure. In case of
doubt, it is the use that emerges as usual from the construction, design and function of the product
1.7 Use
Check the device before use and check it for damages. Protect the device against water and humidity. Never
spray any water on the machine and never immerse it in water. After unpacking check if all accessories are
present. The installation, maintenance and other work must be performed by qualified staff.
The manufacturer can never be held liable if the aforementioned is not followed.
As we are constantly working on technical improvements, adjustments can be implemented without informing
you about this in advance. Keep the control panel free from dirt and grease.
www.combisteel.com
5
Publicité
Table des Matières
