Trouble Shooting - Grizzly ERM 1642 Q-360 Traduction De La Notice D'utilisation Originale

GB

Trouble Shooting

Problem
Equipment
does not start
Motor stops
Result unsat-
isfactory or
motor labours
Blade ( 21)
fails to turn
Strange nois-
es, rattling or
vibrations
Level indicator
( 12) does
A
not work
34
Possible Cause
Power is off
Defective start lever
( A 2)
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 21) blunt
Blade ( 21) area blocked
Blade ( 21) assembled
incorrectly
Blade ( 21) blocked by
grass
Blade screw ( 19) loose
Blade screw ( 19) loose
Blade ( 21) damaged
Contamination
Fault Fixing
Check the socket, cable, wire
and plug and have any repairs
carried out by an electrician
Repair by customer services
Set a greater cut height. Lift
the front wheels slightly by
pressing down on the handle
bar.
Remove the foreign object
Set a higher cut height
Have the blade (
ened or replace it
Clean the equipment
Install the blade (
rectly
Remove the grass
Tighten the blade screw (
Tighten the blade screw (
Replace the blade (
Cleaning with a soft brush. The
level indicator must close by
itself, if it was opened.
21) sharp-
21) cor-
19)
19)
21)