Connecting A Control Device For Using The Remote Control Software; Connecting The Remote Keypad - Analog way Di-Ventix DVX8022 Manuel Utilisateur

Di-VentiX™

2-2. CONNECTING A CONTROL DEVICE FOR USING THE REMOTE CONTROL SOFTWARE

Your Di-VentiX is shipped with a Windows compatible Remote Control Software (3.5" disk). This software allows you
to control and do all adjustments by a simple mouse click.
NOTE: Preferably use Windows NT, 2000, or XP for LAN operation.
2-2-1. CONNECTING TO THE RS-232 PORT
- Connect the serial port of your control device to the RS-232 port (DB9 Female connector) of the Di-VentiX with
a straight cable (DB9 Female / DB9 Male).
- Speed transmission: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.
- Pin-out:
PIN #
2
3
5
2-2-2. CONNECTING TO THE LAN PORT
- Connect the LAN port (RJ45 connector) of the Di-VentiX to your network according to your installation.

2-3. CONNECTING THE REMOTE KEYPAD

2-3-1. CONNECTING TO A Di-VentiX WITH THE RS-232 PORT
Turn OFF your Di-VentiX (rear panel switch).
Connect the RS-232 connector (DB9 female) of your Di-VentiX to the DB9 male connector of the REMOTE
KEYPAD with the supplied DB9 M/F cable.
Turn ON your Di-VentiX (REAR panel switch).
NOTE: The REMOTE KEYPAD is powered by the Di-VentiX via its DB9 (RS-232) connector.
2-3-2. CONNECTING TO A NETWORK (LAN)
Connect the power supply to a power outlet and to the DC-IN connector (rear panel).
Connect the REMOTE KEYPAD to your network according to your installation.
FUNCTIONS
TRANSMIT DATA (Tx)
RECEIVE DATA (Rx)
GROUND (Gnd)
DB9 female (Rear panel of the DVX8022)
Figure 12
Figure 13
Chapter 2 : CONNECTING (continued)
PAGE 15