References; Optional Accessories; Di-Ventix Installation - Analog way Di-Ventix DVX8022 Manuel Utilisateur

Chapter 1 : INTRODUCTION (continued)

1-3. REFERENCES

MODELS &
OPTIONS
DVX8022
OPT-iX-A
CBD-UP

1-4. OPTIONAL ACCESSORIES

REFERENCES
RK8022
RK8022-T
TRC8022
SWM-OE

1-5. Di-VentiX INSTALLATION

IMPORTANT: Please read all of the safety instructions (pages 4 to 6) before starting.
• Table top mounting: The device can be used directly on a table: the unit is equipped with 4 plastic feet.
• Rack mounting:
IMPORTANT: - The openings in the side and in the rear panel are for cooling. Do not cover these openings.
- Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the Di-VentiX.
- The maximum ambient operating temperature must not exceed 40 °C (104 °F).
- The rack and all mounted equipment in it must be reliably grounded to national and local
PAGE 8
Di-VentiX.
Optional AUDIO input/output.
™
CROSS BLENDER . Optional version for "Edge blending" application.
Remote keypad.
Remote keypad with T-BAR.
Remote console. Allows to control up to 3 iX Range devices.
Remote control Software. Allows to control up to 16 to iX Range devices.
The device is compatible with a 19" enclosure. Please follow the instructions below to install the
device in a 19" rack.
Place the device in your rack.
NOTE: Your rack must be equipped with some braces.
Attach the device to the rack by using 4 screws in the front panel holes (screws are not
included).
Connect all of the cables of the device and attach them to the rack with some tie wraps.
electrical codes.
DESIGNATIONS
DESIGNATIONS
Figure 1
Di-VentiX™