Making Connections For Viewing Images To Be Printed - Sony UP-2300P Mode D'emploi

Connections (continued)

Making Connections for Viewing Images to be Printed

66
Installation and Adjustment
Connect a video monitor to view stored images and to check those to be printed.
Connect the necessary video monitor which will be used in actual printing, using
the following diagram as a guide.
Before connecting the video equipment, see "Important safeguards/notices for use
in the medical environment" on page 2.
UP-2900MD/2950MD
REMOTE
RS-232C
1 2
to RGB/SYNC
OUTPUT
75-ohm coaxial cable
with BNC connectors
to RGB input
connectors
a) The RGB/SYNC INPUT connectors are equipped with models other than UP-2300P/2330P.
When you connect the video monitor to RGB SYNC OUTPUT, set SYNC ON G to ON on the OUTPUT
SETUP menu.
b) This selector is equipped with UP-2900MD/2950MD only. Set the NTSC/PAL selector to your TV
system. To switch the TV system, turn the power off once, then change the setting. If you change the
setting with the power on, the mode will not be switched.
NTSC/PAL
selector
INPUT
R G B SYNC S-VIDEO
OUTPUT
R G B SYNC S-VIDEO
a)
to S-VIDEO
OUTPUT
Connecting cable
(with DIN 4-pin
connectors) YC-
15EV
to S-VIDEO
input connector
to composite video
input connector
Video monitor
NTSC
b)
PAL
VIDEO
NTSC
PAL
VIDEO
~
AC IN
to VIDEO
OUTPUT
to AC IN
AC power cord
to wall outlet
75-ohm coaxial
cable with BNC
connectors