Sony UP-2300P Mode D'emploi page 18

Making Full-Size Printouts (continued)
18
Operation
Note
• Do not turn off the power during printing.
If you do so, paper may not be ejected and may jam in the printer.
• Do not pull the paper from the paper cover until printing has been completed.
• You can not change the printer application mode or settings on the WINDOW
SETUP menu during printing.
To stop printing
Press the STOP button. Printing is abandoned and the paper is ejected to the print
tray.
If the printer does not print
The printer will fail to print in the following cases:
• While an error message is displayed on the monitor screen and printer window
display.
— In this case, the paper is ejected without printed even if you press the PRINT
button. Proceed as described in "Error/Warning Messages" on page 103.
• Image is not stored in the memory.
— Image data stored in the memory is lost if you turn off the power. Capture the
image into memory again, then press the PRINT button.
When you want to see an image that is hidden below a screen
message
You can erase the screen message from the video monitor screen by pressing the
DISPLAY OFF button. The screen message disappears. To display a screen
message, press the DISPLAY OFF button again.
If a black line appears on the printout
Sometimes, a black line appears on the printout, although it does not appear on the
video monitor. This black line can be eliminated from the printout. (see "Changing
the Printout Size/Printout Area" page 82)
If the image quality of printouts is not satisfactory
You can adjust the image quality of the printouts. (See "Adjusting the Printout
Color" pages 75)
Notes
When storing your printouts:
• Avoid storing the printout in a location subject to high temperatures, high
humidity, excessive dust and direct sunlight.
• Do not stick tape on a printout. Also, avoid leaving a plastic eraser on a printout
or placing a printout in contact with materials which contain plasticizer (under a
desk mat, for example).
• Do not allow alcohol or other volatile organic solvents to come into contact with
the printouts.