Tunturi Pure U bike 2.1 Mode D'emploi page 6

Assembly step B
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
• Verbinde die Kabel vom Upright-Tube
und Hauptrahmen bevor Sie den
Upright tube in Position
• Verwenden Sie den Beiliegenden
Inbus-Schlüssel um die
Befestigungsschrauben zu befestigen
(Uhrzeigersinn).
•
Bemerkung:
• Drehe alle 6 Bolzen erst handfest
bevor diese nachgezogen werden um
falsche Ausrichtung zu vermeiden.
•
• Montiere den Seat auf dem Seat-
Tube.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
• Fix the seat to the seat tube.
6
Assembly step D
• Lead the wires for hand pulse
reading through the hole towards the
display assembly opening.
Remark:
Avoid the wires to damage during
assembly..
• Fit the handlebar to the upright tube
by using the shown hardware..
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step E