Checking Bolts And Nuts - Yamaha Z150P Manuel D'utilisation

r e t y
q
w
8 Using an accessory battery
Use a connecting cable between the (–)
terminals of the starting battery and
accessory battery. See the illustrations of
the wiring connections. This cable must
be made from wire equivalent to the start-
ing battery cable 3.
w
901014*
Use of smaller wire could lead to a fire.
1 Battery for starting
2 Battery for accessories
3 Large red lead for starting battery
4 Small red lead for accessory battery
charging (optional part)
5 Large black lead
6 Negative connecting cable
NOTE:
If a battery selector switch is desired, con-
sult your YAMAHA dealer about correct
wiring.
EMU01280
Disconnecting the Battery
Disconnect the BLACK lead from the NEG-
ATIVE (–) terminal first. Then disconnect
the RED lead from the POSITIVE (+) termi-
nal.
EMU00408

CHECKING BOLTS AND NUTS

1) Check that bolts securing the cylinder
head and engine and the nut securing
the flywheel are tightened with their
specified tightening torque.
2) Check the tightening torque of other
bolts and nuts.
4-29
GB