Before Using The Kr103; Connections; Connecting The Pedal Cable; Connecting The Power Cord - Roland KR103 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.

Before using the KR103

Connections

Connecting the pedal cable

Insert the pedal cable into the
[Pedal] connector on the rear
panel of the KR103.

Connecting the power cord

Insert the included power cable into the AC inlet on the
KR103, and then plug it into an electrical outlet.
Be sure to use the supplied power cord.

Setting up the music stand

Set up the music stand as shown in the figure below.
Fold the three supporting feet at the back of the
stand and check whether the stand is held in place.
Before moving the KR103, be sure to lower the music
stand as a safety precaution.
KR103 Digital Intelligent Piano

Opening/closing the lid

(1) To open the lid, use both hands to lift it lightly, and
slide it away from yourself.
(2) To close the lid, pull it gently toward yourself, and
lower it softly after it has been fully extended.
• When opening and closing the lid, be careful not to
let your fingers get caught. If small children will be
using the KR103, adult supervision should be pro-
vided.
• If you need to move the instrument, make sure the
lid is closed first to prevent accidents.

Connecting headphones

The KR103 has two jacks for plugging in headphones.
This allows two people to listen through headphones
simultaneously, making it very useful for lessons and
when performing piano pieces for four hands. Addi-
tionally, this allows you to play without having to
worry about bothering others around you, even at
night.
Plug the headphones into the phones jack located at
the bottom left of the piano.
Connecting headphones will automatically mute the
sound from the internal speakers.
The headphone volume is adjusted by the [Volume]
knob of the KR103.
Phones socket x2
Phones plug x 2
Be sure to use stereo headphones (such as the Roland
RH-25, RH-50 or RH-200).
INotes on using headphones
• To prevent damage to the cord, handle the head-
phones only by the headset or the plug.
• Connecting the headphones when the volume of
connected equipment is turned up may result in
damage to the headphones. Lower the volume on the
KR103 before plugging in the headphones.
• Listening at excessively high volume levels will not
only damage the headphones, but may also cause
hearing loss. Use the headphones at a moderate vol-
ume level.
r
Setting up the music stand
11

Publicité

Table des Matières
loading

Table des Matières