Manual Temperature Preselection - Sygonix tx.5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Manual Temperature Preselection
You can skip the present programming at any time and manually
set the desired temperature.
This function is available only if a programming is present
(see chapter 9. b).
This is not the case at initial commissioning (or after re-
start). Therefore, manual temperature settings cannot
be made at this time either.
1.
The room thermostat must be in the regular display (time/
temperature in the display).
Programming must be present at just described.
2. Set the desired manual temperature with the buttons –" (3)
or „+" (2) (a hand icon appears).
The temperature can be selected within the set temperature
limits (see chapter 9. h).
3. Confi rm the setting with "OK" (5).
The room thermostat then is back in regular display.
4. The temperature can be changed at any time with the but-
tons "–" (3) and "+" (2) while the hand symbol is visible in the
display.
Manual operating mode is automatically terminated when the
next switching point according to the programming is reached
(e.g. on the next day).
You can also personally terminate manual operating mode by
briefl y pushing the button "MENU" (4) or "OK" (5).
If manual mode was terminated, the hand icon disappears. The
temperature control is taken over by the set programme again.
82
The home technology brand for the entire house. More information at www.sygonix.com

Publicité

Table des Matières
loading

Table des Matières