Sygonix tx.5 Mode D'emploi page 57

• Function G13 "BACKLIGHT"
Backlighting (at push of a button) on/off
►
Menu "INSTALL SETTINGS"
• Function H1 "HEAT OR COOL"
Switching between heating and cooling operation (depending
on the desired operating mode or the connected consumer
(heating or cooling device)
• Function H2 "VALVE PROTECT"
Scale protection for heater valve on/off
• Function H3 "FROST PROTECT"
Frost protection on/off
• Function H4 "OPTIMUM START"
The connected consumer may be activated earlier to reach the
desired temperature more quickly
• Function H5 "RESET ALL"
Resetting to room thermostat to factory settings
After activating the main voltage, fi st programme date
and time (function G5).
Select either heating more ("HEAT") or cooling mode
("COOL") in function H1. Heating mode is active in the
basic setting.
Use function G1 to select one of the 3 programming
slots, then start programing of temperatures/times in
function G2.
The programming for a specifi c day can be copied to one
or several days if required with the function G4.
57