Sygonix tx.5 Mode D'emploi page 49

A device for all-pin separation fro,m the mains voltage
must be provided on the installation side (e.g. FI circuit
breaker).
• The product may be operated stationarily installed.
• The product is constructed according to protection class II.
• Do not use the product inside of rooms or in bad am-
bient conditions where fl ammable gases, vapours or
explosive dust may be or are present! There is a danger
of explosion!
• If you have reason to assume that safe operation is
no longer possible, disconnect the product imme-
diately and secure it against inadvertent operation
(turn out associated fuse or deactivate circuit breaker,
deactivate associated FI circuit breaker) and secure
against inadvertent operation.
Then have the product inspected by a specialist.
It must be assumed that safe operation is no longer
possible, if:
- the product is visibly damaged
- the product does not work or not work properly
(fl ickering light, smoke or burnt smell, audible crack-
ling, discolouration of the product or adjacent sur-
faces)
- the product was stored under unfavourable conditions
- if it was subjected to heavy stress during transport
• Do not leave packaging material unattended. It may
become a dangerous toy for children.
• Handle the product with care. It will be damaged
through impact, blows, or accidental drops, even from
a low height.
• If you have questions which remained unanswered in
these operating instructions, please contact us or an-
other expert.
49