Installing Pp 45 Hyi Humidity Sensor In Rls 45 O Or Rls 45 K - Maico PPB 30 O Notice De Montage

UK | Mounting
PushPull combination system with PP 45 EO
PP 45 EO extension module can only
i
be combined with PP 45 RC/PPB 30
RC units. Wired operation is needed for
other unit types.
1. Install the EnOcean extension modu-
le. For more information  Accessory
instructions. If necessary, plan a separate
distribution box for the wiring.
2. Connect EnOcean extension module to
RLS 45 K control (RS 485)  Connection
diagrams in the appendix.
3. Start up ventilation system, activate
EnOcean in service mode  Chapter 8.
PP 45 Act EnOcean actuator
With the PP 45 Act, radio-controlled PP 45 RC/
PPB 30 RC units can be combined with wired
exhaust air units (ECA, ER). Installation similar
to light switch installation; can be switched on
and off at the touch of a button. For further
information  Mounting and operating instruc-
tions for PP 45 ACT.
42
9.9 Installing PP 45 HYI humidity sensor
in
RLS 45 O or RLS 45 K
1. Install room air control as described in
Chapter 9.7.
NOTICE
Unit damage/no function if the humidity
sensor is installed incorrectly. Do not bend
pins. Insert sensor up to stop in bush.
2. Insert PP 45 HY humidity sensor at I2C
interface Arrow.
3. Fit frame so that it engages.
Ensure that sensor opening (hole in
i
frame) is above the PP 45 HYI sensor.
4. Start up ventilation system and register
humidity sensor in service mode 
Chapter 10.
5. For installation and wiring of an external
sensor  Commissioning instructions.