Power Trim/Tilt Switch - Yamaha F40C Manuel D'utilisation

UP
DN
EMU01125

POWER TRIM/TILT SWITCH

The power trim/tilt adjusts the motor
angle in relation to the transom. The
power trim/tilt switch is located on the
side of the bottom engine cowling. Push-
ing the switch "UP" trims the motor up,
then tilts the motor up. Pressing the
switch "DN" tilts the motor down and
302011*
trims the motor down. When the switch
button is released, the motor will stop in
its current position.
w
Use the power trim/tilt switch located on
the bottom engine cowling only when
the boat is at a complete stop with the
engine off. Attempting to use the cowl-
ing-mounted power trim/tilt switch while
the boat is moving could increase the risk
of falling overboard and could distract
the operator, increasing the risk of colli-
sion with another boat or an obstacle.
NOTE:
Refer to the section "Adjusting Trim
Angle" and "Tilting Up/Down" for instruc-
tions on usage.
2-9
GB