Güde GTB 13/5 Mode D'emploi page 25

GTB 13/5
Inspection and maintenance plan
Regular servicing period
Check the safety equipment
Check the V-belt and tighten
it if necessary
6
Apply a thin layer of oil on
the pillar and the bench
Angle drift to be cleaned
Remove drill cuttings and
metal chips from the device
Provide appropriate servicing upon the earlier of the following: in the given month or after the specifi ed hours of
operation have expired.
Failure removal
Failures Causes
Engine not The micro switch in the belt housing prevents starting if
starting the housing is not closed properly.
V-belt tight too much
Drill is turning The choke is not fi tted properly on the angle drift.
unevenly
Before Whenever
any start- the device
up is put into
operation
operation



If necessary

After 1 After 3
months months
20 50 100 Hours
Hours of Hours of of opera-
operation
Removal
Close the belt housing
properly!
Belt to be loosened a little
bit
Push in the chuck by light
tapping.
ENGLISH
After 6 After 12
months months
300 Hours
of opera-
tion tion
21