EUROM HEAT Plug-in Manuel D'utilisation page 25

Location and connection
 Remove all packaging material and keep out of reach of children. After
removing the packaging, check the appliance for damage or other signs of a
fault/defect/malfunction. In case of doubt, do not use the appliance and contact
your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Set-up and operation
 Make sure that the heater is switched off (O pushed in) then plug into a
correctly functioning 220-240V / 50Hz socket.
 Now set the main switch to I (on); the heater is now on standby and the
indicator light (7) lights up.
 Switch on the heater by pressing the ON/standby button.
 After switching in by means of the main switch, the thermostat is on the
maximum: 30°C. Press the 'Temperature lower' button to set the desired
temperature (minimum 15°C). With the 'Temperature higher' button you can
higher the set temperature afterwards. The display shows the set temperature.
 The thermostat will now regulate the heater to turn on if the temperature is too
low and off once the desired temperature is reached.
 Press Temp + and Temp - at the same time to speed up the fan or to slow it
down. The display shows for a moment flashing what you have set: LL=low,
HH=high.
 Press the timer button to set the timer. The display changes from degrees to
hours. Hold in the button to enter more hours, up to a maximum of 12.
Power-off: If you set the timer while the heater is on, you set the number of
hours after which the heater turns itself off.
Power on: If you set the timer while the heater is set to standby, you set the
number of hours after which the heater turns itself on.
 To switch off the heater you must first set it to standby by pressing the
ON/standby button. The heater will stop heating, but the fan cools for another
60 seconds (see display) before switching off. You can then use the main switch
to turn off the heater properly (O pressed). Never leave the plug in the socket
when the heater is not in use!
Safety features
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater or obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, you need to turn the switch to the 'O' position (off) and
25