Use; Cleaning; Decalcification - Proficook PC-WKS 1123 Mode D'emploi

Switching on / off
• Switching on:
Press the toggle switch downwards. The indicator light in
the switch lights up.
• Switching off:
Press the toggle switch upwards. The indicator light in the
switch goes off.

Use

NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Press the button in the handle to open the kettle.
3. Then fill in the water (max. 0.8 Litre). You can read the
filling level on the water level indicator of the kettle.
4. Close the lid. Press down on the contact area (2) to close
the lid.
5. Place the kettle flush on the base.
6. Only connect the appliance to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch. The control
lamp in the switch will light up.
WARNING:
• Always turn the device off before cleaning it and remove the
mains plug. Wait until the device has cooled down.
• Never immerse the device or the base in water or other liquids.
Otherwise this might result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents
• Clean the perforated area of the spout from the inside
with a nylon brush.
• Rinse the water container out with clean water. Then dry
it off with a cloth.
• Clean the housing after use with a slightly damp cloth.
PC-WKS1123_IM_new
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
2. Push the rocker switch upwards to finish operation.
CAUTION:
Do not remove the appliance from the base without shutting
it off first
The contacts on the base are not suitable for disconnecting
the power supply.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not
touch it and allow the device to cool down before storing
it away.
• Disconnect the power cord.
• Emptying the water container.
Mains Cable Take-Up Device
The mains cable can be wound up on the base.

Cleaning

• The frequency of the decalcifying operation depends on
the hardness of the water and on how often the appliance
is used.
• If the appliance switches off before the water boils, it prob-
ably needs to be decalcified.
• Please do not use vinegar but a commercially available
decalcification agent on the basis of citric acid. Only use
the quantities stated in the instructions.
NOTE:
After descaling the device boil fresh water in it several
times (approximately 3 - 4 times) in order to remove any
residues. Do not consume this water.

Decalcification

17.01.17
35