Overview Of The Components; Delivery Scope; Unpacking The Device; Notes On Use - Proficook PC-WKS 1123 Mode D'emploi

• This appliance is used for heating and boiling water. Never use to
heat up other fluids or foodstuffs. This can cause injury.
• Only use the appliance in a dry, indoor area. It is intended for do-
mestic use and similar areas of use such as e.g.:
- In staff kitchens in shops, offices and other commercial areas;
- By guests in hotels, motels and other accommodation facilities.
It is not intended for use in farm accommodation or Bed & Break-
fast establishments.
• The following symbols are on the product:
CAUTION:
Do not immerse the device into water for cleaning. Please follow
the instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Spout
2 Contact area for closing the lid
3 Lid
4 Button for opening the lid
5 Handle
6 On / Off switch
7 Base
Not shown:
Water level display in the interior

Delivery Scope

1 x Water kettle
1 x Base

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all packaging materials such as films, padding,
cable holders, and cardboard.
3. Check the packaging contents for completeness.
4. Check the device for any transport damage in order to
avoid hazards.
NOTE:
If there is any visible transport damage, contact your dealer
immediately. Do not operate the device if damaged!
34
PC-WKS1123_IM_new

Notes on Use

Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical Connection
Check whether the electrical voltage that you intend to use is
the same as that of the appliance. Details are to be found on
the label on the base.
Connected Wattage
The total power consumption of this device can be up to
2000 W. With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is too
powerful.
17.01.17