Supplied Parts; Unpacking The Appliance; Description Of Parts; Electrical Connection - Proficook PC-WKS 1020 G Mode D'emploi

• This appliance is used for heating and boiling water. Never use to
heat up other fluids or foodstuffs. This can cause injury.
• Only use the appliance in a dry, indoor area. It is intended for do-
mestic use and similar areas of use such as e. g.:
- In staff kitchen areas in shops, offices and other working envi-
ronments;
- By guests in hotels, motels and other residential type environ-
ments.
It is not intended for use in farm houses or Bed & Breakfast type
environments.
• The following symbols are on the product:
CAUTION:
Do not immerse the appliance into water for cleaning. Please
follow the instructions as stipulated in the chapter "Cleaning".

Supplied Parts

1 Kettle
1 Lid
1 Base
1 Lid with a tea strainer

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".

Description of Parts

1 Spout (opening)
2 Lid
3 Contact area for opening / closing the lid
4 Handle
5 Base
PC-WKS1020G_IM_new2
6 Tea strainer
7 Water level indicator
8-11 Function buttons 70 °C / 80 °C / 90 °C / 100 °C
12 keep warm function
13 on / off

Electrical Connection

Power Requirements
The appliance can consume 3000 W of power in total. At
this power rating we recommend a separate lead with fuse
protection through a 16 A circuit breaker.
CAUTION: OVERLOADING!
Do not use extension leads or multiple sockets since this
appliance is too powerful.
Connection
• Before plugging the mains plug into the socket, check if
the mains voltage which you want to use matches that
of the appliance. The details can be found on the name
plate on the base.
• Only connect the appliance to a properly installed
earthed 220 – 240 V~, 50 Hz socket.
37
08.03.18