Medication Reminder - Microlife BIOS Diagnostics 3AL1-3E Manuel D'instructions

3.7 Medication Reminder

This instrument allows you to set two alarm times at which an alarm signal will then be triggered. This can be
a useful aid, for instance as a reminder to take medication or to remind you to take your blood pressure at the
same time each day.
1. To set an alarm time, press the
beforehand) and immediately afterwards the
symbol appears in the bottom left of the display. Then release both buttons. The flashing "1"
in the display indicates that the first alarm time can now be set.
2. Press the button to set the hours – the hours display flashes and pressing the
allows you to set the alarm hour. To confirm, press the time button
3. The minute display will now flash. The minutes can be set using the
press the button again.
4. The symbol will now flash. Use the
or inactive . To confirm, press the time button.
To set a second alarm time, proceed as above but if the "1" flashes, press the
select "2" and confirm with the time button.
• An active alarm time is indicated by the bell symbol in the display.
• The alarm sounds at the set time every day.
• To switch-off the alarm when it is sounding, press the
• To permanently switch off the alarm, proceed as above (steps 1-4) and select the crossed
out bell symbol.
This will then disappear from the display.
• The alarm times must be re-entered each time the batteries are replaced.
button (the instrument must be switched off
button and hold both down until the bell
button to select whether the alarm time is to be active
button. To confirm,
button.
button
button to