Interruption Of Work; Taking Out Of Operation And Cleaning - WAGNER WallPerfect W 565 Mode D'emploi

W 565
Fig. 7 A: CORRECT Even distance to the object.
Fig. 7 B: INCORRECT An uneven distance will result in uneven paint application.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
If nozzle and air cap are soiled, clean both parts with water and solvent.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 8).
i Interior wall paint in strong colour shades should be applied at least twice
(allow first paint coat to dry first). This will ensure good coverage.
Important: Wipe off the nozzle and air cap regularly to
i
make sure they do not get blocked.

15. Interruption of Work

•
Turn the machine off.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.

16. Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1) Unplug the power plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 3 b "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
3) Unscrew the container. Empty any remaining coating material back into the material
tin.
4) Preclean the container and feed tube with a brush. Clean the ventilating bore (Fig. 9,
1).
5) Pour water or solvent into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6) Assemble the gun again (Fig. 3).
GB
25