Aquatec Ocean Mode D'emploi page 9

Assembly and installation
Adjusting the backrest cover
The tension of the backrest can be adjusted as desired.
Tightening
1. Pull the belts of the backrest cover tighter.
A
Loosening
1. Open the buckles by squeezing the retaining lugs together (ar-
B
rows).
2. Push the belts back a little through the buckle.
3. Close the belt buckles.
4. Retighten the belts gently.
Shower and Toilett Commode Ocean / Ocean XL
Adjusting the height of the armrests
IMPORTANT
▸ Adjust the height of the armrests to suit the user.
▸ Change the height of the armrests evenly on both sides.
▸ Set the height of the right and left armrest in the exact same
manner.
1. On the backrest cover, open the buckle of the belt that passes on
the inside of the backrest frame.
2. On the backrest cover, open the buckle of the belt
above the armrest.
3. Pass this belt on the inside of the backrest frame and reclose.
The nuts are inserted loosely in the retaining clamp and can
i
fall out.
4. Unscrew the screws of the armrest bracket
B
key supplied.
5. Remove the securing clamp
backrest frame.
that runs
C
using the Allen
A
with the nuts from the inside of the
D
9